-
First to explain the facts I have to make a premise.
I know nothing if this is the right place neither the contents are pertinent, since actually what I will describe is not directly related with the…
-
### Describe the problem
In order to upload to an Arduino board via a serial port, the upload tool (e.g., [**AVRDUDE**](https://github.com/avrdudes/avrdude)) must be able to open the port. This is no…
-
I finished solder this board. so i want to test it.
I burned the firmware to eeprom using tools from P8X Game System download page.
but, the board is doesn't work.
/WAIT signal is going to low im…
-
Trying to use usbasp as a programmer for certain attinys (I tried with ATTINY828) does not work, as the avrdude.conf supplied by the attiny core needs to be used. Original thread: https://community.p…
-
I am using "esp-link v2.2.3 - 2016-06-21 21:58:48 - 1bcdc62", with a Wemos D1 ESP8266 v4 and am not able to flash a connected Arduino Uno R3 and cannot figure out what's the issue.
Flashing through…
-
Some of the problems we've seen have been to do with the printer sketch size. @lazyatom mentioned that some of these are to do with older arduino bootloaders. I'm wondering whether it'd be possible …
-
Hi JonahTsai,
I wonder if you have implemented the MLX90363 sensor reading? Your project is wonderful, I haven't found anything like it in literature.
I tried to sign up for a forum, but it is b…
-
I'm working through the Arduino library code and the firmware code to see if I can trace this down, but it seemed like a good time to open an issue for some help.
I have two Twists that have both …
-
Hello,
To use your configuration, do I have to make any special settings ? I replaced my EFI partition with your 1.2 release but I get kernel panic. I'm not sure it can be, I got the following:
…
-
Hi there,
I’ve been following this project for a while and I’m going to try it for myself soon. I have a Dell XPS 9530, on which I have found the following chip that I suspect to be the BIOS one:
…