-
Thank you very much for this wonderful guide. I have klipper installed and FFCP is running better then ever. When installing 2209 drivers do I still need to flip the pins to the other side or can I …
-
whenever I try homing I get the error: TMC 'stepper_z' reports error: GSTAT: 0000001d reset=1(Reset) uv_cp=1(Undervoltage!)
I know it's not actually a problem with voltage as I have checked
-
Hi all! I'm fairly seasoned with Processing and Arduino but brand new to RAMPS and 3D printing hardware. I got a RAMPS v1.6 board, graphic LCD with SD reader, and Arduino Mega. Good news, I got the fi…
-
https://www.amazon.com/BIGTREETECH-SKR-E3-V3-0-Motherboard/dp/B07YW86YS7
Thinking about moving to this mainboard, but I do not know whether there is a big enough need in order to do so. Will need t…
Vlek updated
11 months ago
-
Hi All... Quick background, I started the ELS project along with James Youtube tutorials. Got to the point of bench testing,
then uprooted myself from AZ and moved to Idaho. Finally have my new shop…
-
hi.
i using skr2 + tmc2209 in my 3d printer
recently, my tmc2209 driver was damaged after printing over 24h, 35°C (stepper is nema 17HS3401, 24V)
then, i found that reason is short between G…
-
My last parallel port PC died, so I have to take drastic action...and made the changes to the latest .9i 03292025 build to support the MaxNC10 (pre 2004) phase signal drivers. This came at the expens…
-
When trying to operate my cnc the X-Axis will switch directions no matter what direction the command is given in (i.e. if it is told to step 10 mm in the minus directions 5 times after the 3rd it will…
-
Some G2 commands are throwing assertion errors. For example:
```
----- Hardware not detected, using virtual environment -----
----- Use M111 command to enable more detailed debug -----
*********…
-
Hi, I build your project. The project is really helpful, but I have an issue. When I input values in the Nextion display, The stepper motors stop for a second after every revolution of the stepper. It…