-
Hi folks,
I was trying to use PWM on pin PB_2 on a launchpad tiva with Eneriga but my program crashed, after some searching i found out there is a bug in enableTimerPeriph() in the file wiring_analo…
-
I'm using Energia 0101E0014 with a Tiva-C Launchpad and using the Wire library to connect to some peripherals.
My code worked initially with Arduino Mega and then I ported it to the Launchpad.
I real…
-
Hi --
Can we extend the baud rates in Energia/app/src/processing/app/SerialMonitor.java?
I can run the serial at higher than 115200 on Stellaris / Tiva, but can't test at that those speeds with the S…
-
-
My initial program:
---
# define RLED RED_LED
# define GLED GREEN_LED
void setup()
{
pinMode(RLED, OUTPUT);
pinMode(GLED, OUTPUT);
digitalWrite(RLED, HIGH);
delay(1000);
digitalWrite(RL…
-
Hi,
again, I'm having a strange issue - which might well be on my part, but I'm not sure where to look.
We changed our MCU on the new board but kept all the code and also the flash chip, so after impl…
-
-
Any plans to make the rest of the source code open source too?
E.g. the part it talks to the hardware.
Like Trezor has it: https://github.com/trezor/trezor-mcu
If the hardware files provided from th…
-
In the file: LIDARLite_Basics/TI_Tiva_C_Series/main.c
I2C addresses look inverted, Write should be 0xC4 and Read should be 0xC5
-
after we press a button next message should be sent either:
- after 30 seconds
- when we press this button again
can be useful for flight day as well as it's easier to test