-
the new SB EBB can board with 2240 TMC driver has some issues I get Section 'tmc2240 extruder' is not a valid config section on start
-
It would be great to have a setting where the display stays on during a print and then goes back to the set time afterward.
-
I've been fighting this issue for months now on my diy IDEX build. I have the BTT E3 RRF V1.1 along with the IDEX expansion board. It oscillates +/- 15 degrees around the desired temperature.
I…
-
Ive been using klipper for a while now but decided to switch back to marlin for some features id like to be supported. When I load the SD card with the "firmware.bin" file it doesnt do anything. If I …
-
With Marlin-bugfix-2.0.x-SKR-V1.4 release of 31/01/2021, when I set EXTRUDERS 0, the compilation cannot end.
Compiling .pio\build\LPC1768\src\src\lcd\extui\anycubic_chiron_lcd.cpp.o
In file includ…
-
Can BTT release basic component schematics for this board, as I have several with damaged PWM fan headers, and I would like to repair them.
-
Hello,
I have a 3.5 TFT v1.0, it wasn´t connecting to my board (MKS Sbase v1.3), then I updated the firmware. After the firmware update most icons are not correctly displayed, and boot image is wro…
-
The following defect was described in the Marlin 2.0.x build that this one is built from (note link below):
https://github.com/MarlinFirmware/Marlin/issues/13287
The gcode M190 is used to make t…
-
Hello !
Everything went fine with my new skr 1.3 ( Marlin 2.X ( Ender 5 ) for about 20 prints.
Suddenly when i start my printer i get a constant beep tone and
a blue screen ( Stock Creality scree…
-
I have BIGTREETECH-S42A-V1.0 motor and driver. working on 0.38 firmware. To make it work i need to change some pins in board.h. With the same config pins on FW 0.39-0.40 do not work any more. Every th…