-
Hello,
I was trying to imitate your work on ESP32 hardware with default settings and pin configs.
I cloned the git repository, made a new project using VS Code ,PlatformIO and Arduino.
with some …
-
Ethos 1.4.17. Have not checked 1.5.0-RC3 yet.
The maximum voltage for ISRM sensor ID `0A 0B50` is only 50.00v, which causes problems with a fully charged 12S LiHV setup (and sometimes even full cha…
-
### Is there an existing issue for this bug?
- [X] I have searched the issues and there is no existing issue for this bug.
### What development environment are you using?
PlatformIO
### What board…
-
## Current Behavior
First I installed ExpressLRS lua script on OpenTx 2.3.13 it was working fine.
Then I decided to upgrade the whole radio to newest EdgeTX (2.8.0) along with SD card content up…
-
after updating to 1.5.0 on x20 crsf config under ext rf unit no longer works shows tx module and reciever but when you click on tx module all that is shown is bind no other configuration
-
Hey @AlessioMorale , thank you for this CRSF parser, it helped me a lot already, please lmk if there is a way I can donate you for this effort?
I'm looking for a solution to aggregate several physi…
-
I observed on a Frsky RB10 (redundancy box) an inconsistent response of the RB when setting the oXs into failsafe. The RB did not switch to the still operating input channel but stayed on the datastr…
hw999 updated
7 months ago
-
### Describe the bug
Quando attacco la LiPo in OSD non vedo i dati del GPS
### To Reproduce
Appena finisce il fix sento solo che il beeper suona, ma in OSD non vedo nessun dato di volo riguardante …
-
Laravel Caffeine refreshes the CRSF token every `drip-interval` and refreshes the whole page when the session almost expires; `outdated-drip-check-interval` before. But... when I open the Laravel appl…
-
Which setup do I need to get offline maps with Zorro on Edgetx and ELRS Rx with GPS sensor? So no flight controller. Thanks