-
Hello,
I can not run a calibration with Marlin-1.1.0 RC7 (1.0.xxx OK) and Scara kinematic
I made a `G28`
then `M360` to move Theta 0 ° position
a look back `M114` (SCARA Cal - Theta: -17.82)
a …
-
I tried to move the z axis through the menu; prepare > move axis > 1mm > z axis > increase from 0 to 170mm, which is a long travel and had to do several rotation on the encoder to reach to that point.…
-
I'm trying to get Marlin-RC4 working on my Kossel XL.
It seems to be working, except for the auto level. After sending the `G29` command the printer starts with auto level, but when the z-probe switch…
-
Hi,
I have a RepRap Prusa Mendel RAMPS 1.4. I have ran an old version of Marlin on this machine for nearly a year, but need to get the Marlin version updated so I can use the servo functions. I plan…
-
**Describe the bug**
The Gap fill that is produced has a way higher width than the perimeter width
**To Reproduce**
Steps to reproduce the behavior:
use a relatively thick extrusion width. (i us…
-
Hi,
i have an problem with this.
Moves are all fine.
in print, it puts the tracks in order 1-2mm direction Endstop.
Where is my mistake?
The driver to fast for marlin?
I print with 60mm/s.
Or is ther…
-
_From @AnHardt on November 22, 2015 18:23_
Hardware Endstops
A small collection of problems with hardware endstops. I'm not sure i'v got all of them.
Sorry. I was to lazy to search for all the origi…
-
### Version
V2.2.53
### Operating system type + version
Win10 + v1909 vSO 18363.1139
### 3D printer brand / version + firmware version (if known)
Custom Printer + SKR V1.3 + Marlin 2.2.7.1
#…
-
Z CLEARANCE BETWEEN PROBES does not work with bltouch.
G28 works beautifully, G29 does not work.
The z axis does not move up, after the first measurement point.
``` cpp
#define BLTOUCH
#define Z_ENDS…
-
After upgrade from RC5 to RC6 after each layer, all layer step by XY coordinate