-
Hi Kris,
First of all, I greatly appreciate your work here! I love it.
First maybe some background on my project. I'd like to set up a simple sender-receiver communication using two Ebyte E32-91…
-
Hi @beegee-tokyo, have you ever try the library from MBED for sx1262 in SX126xMB2CAS board for stm32 https://os.mbed.com/components/SX126xMB2xAS/, I already try that library in my Nucleo board, and it…
-
Hello,
I have an EBYTE module [(Product page)](http://www.ebyte.com/en/product-view-news.aspx?id=453) that has a max output power of ~31dBm. Despite modifying the range in SX1262::setOutputPower to m…
-
The functions to set the three parameters below are missing:
_OptionTrans
_OptionPullup
_OptionFEC
I added the functions in EBYTE.cpp / EBYTE.h and it worked perfectly for my use, but maybe yo…
-
-
Hello! Hoping to use the lessons learned from my first attempt at building this device, I used extraordinary caution when assembling my second attempt unit. No detail was too small. (I actually did…
K4KDR updated
3 years ago
-
Ebyte provided new board with CC2652P chip - E72-2G4M20S1E ,but firmware is for Launch.
http://www.ebyte.com/en/product-view-news.aspx?id=1002
According to datasheet is another truth table and ano…
-
## What happened
I have massive problems with zigbee2mqtt.
zigbee2mqtt once a day fails and is unable to start again. „Failed to start zigbee-herdsman“
I can only overcome this by stopping HA…
-
I've seens this device produced by eByte (amogst most of the widely used zigbee module nowadays) and I was wondering if it can be supported by Zigbee2Mqtt due to the fact that:
- its based on CC2530 …
-
hello, I am trying to communicate this type of ebyte e32 modules with ttgo lora esp 32, but it has not been possible to change the addresses, the frequency set them to 915 mhz and I have not yet been…