-
```
The Eggbot Control extension silently ignores some unsupported SVG elements
while providing warnings about other unsupported elements.
To the list of silently ignored elements a few additional e…
-
```
Originally Reported by westfw, May 25 (4 days ago)
If you make changes and "apply" them in the Configuration menu (servo
up/down position, step speed, etc), those changes will be sent to the
eggb…
-
```
Reported by multiple users:
On complex files with multiple layers, it takes too long (minutes, sometimes)
to begin plotting.
The Eggbot Plot extension reads through the whole Inkscape file and …
-
```
Originally Reported by westfw, May 25 (4 days ago)
To find the serial port occupied by the eggbot, the extension code sends a
"v\r" (version) command to each port it sees, looking for an appropria…
-
```
There is an "Engraving mode" option in the Eggbot Control GUI that is not yet
implemented.
The plan is as follows: When the pen is down, we will turn on a digital output
at location B3 on the E…
-
```
Sometimes it is convenient to manually rotate the motor by more than one full
revolution.
```
Original issue reported on code.google.com by `windell@oskay.net` on 20 Jun 2014 at 7:53
-
```
Manual moves above 1000 steps/s fail.
Bad code:
nTime = int( math.ceil( 1000 / self.fSpeed * distance( self.nDeltaX, self.nDeltaY )))
Replace with:
nTime = 10000.00 / self.fSpeed * distance( …
-
```
Once we add 3 byte long step and duration parameters for the SM command, and
add commands for homing, we start to see some things take very long times (a
3-byte duration in milliseconds is 4.7 h…
-
```
The Inkscape extension plots paths in the order of objects that it encounters
in the file.
It would be nice to have an option to optimize the order of plotting.
Some things to consider:
* Op…
-
```
Add new SC commands to allow setting up of two inputs per axis that when
tripped will cause the motor not to step any more in that direction. Make each
input selectable as to high or low being '…