-
Any solution for this problem below?
after `G29` `#define Z_PROBE_END_SCRIPT` `m402` not working
``` cpp
15:29:41.580 : echo:Unknown command: "m402"
```
-
### Version
version_2.2.0.191.gdb49a4516
### Operating system type + version
Archlinux
### 3D printer brand / version + firmware version (if known)
not aplicable
### Behavior
* _Describ…
-
Hello! I have some problems with RC8 and the bltouch as Z min endstop, hope you can help me. I have a MKS gen 1.4 board (#define MOTHERBOARD BOARD_MKS_13) and I have no problems using a mechanical end…
-
### Version
2.3.55.2
### Operating system type + version
Not Important
### 3D printer brand / version + firmware version (if known)
Not important
### Behavior
Problem:
Extruder pat…
-
### Duet Forum Discussion Thread
Not possible: "Login Unsuccessful spawn ENOMEM"
### Which Duet products are you using?
- [ ] Duet2-Wifi
- [ ] Duet2-Ethernet
- [ ] Duet Expansion Breakout Board
- […
-
Superslicer crashes without any notification when slicing the project attached. Also when doing 0.7mm default extrusion width, there are gaps in slicing.
Superslicer Version 2.3.55 daily precompile…
-
Please provide as much information as you can:
* **Suggested term label:**
ATP-dependent DNA damage sensor activity
* **Definition (free text)**A molecule that recognises toxic DNA structures,…
-
This is the same bug as https://github.com/prusa3d/PrusaSlicer/issues/2945 for which I have submitted a PR in PrusaSlicer , but not had a reply.
**Describe the bug**
The z travel speed is the same…
-
I've been using ArcWelder a lot and version 3.5.0 has worked great for me. Unfortunately 3.5.1 has all sorts of problems.
Best shown from an example:
This is Cura. The model is a single layer ri…
-
Firmware version:
3.4.0 final
Tested:
Provided Gcodes for the MMU v2.0
Filaments used:
Prusa / fillamentum filaments
I have tested several times the provided Gcodes and have recognized sev…