-
# 1. ARE YOU REQUESTING SUPPORT?
-- YES / NO --
# 2. If you answered YES to the above question go here instead:
https://www.rcgroups.com/forums/showthread.php?2249574-Cleanflight-firmware-for…
-
# 1. ARE YOU REQUESTING SUPPORT?
-- YES / NO --
# 2. If you answered YES to the above question go here instead:
https://www.rcgroups.com/forums/showthread.php?2249574-Cleanflight-firmware-for…
-
Hi all, hope you guys can help. Im using the following in my setup.
SPRACINGF3 ACRO Flight Controller.
DYS XS30A (with signal cap removed).
All motors work perfectly on Multishot but only 3 o…
-
Clean flight configurator still shows 1.13 for stm32f3 discovery board. Any plans on upgrading this?
-
# A - GPS stopped working during an update to Cleanflight 2.0.2 (from Cleanflight 1.x).
# B -
1. My receiver is PPM mode, so I connected channel 7 TX to RX of GPS, and channel 8 RX to TX of GPS. …
-
# 1. ARE YOU REQUESTING SUPPORT?
-- YES --
# 2. If you answered YES to the above question go here instead:
https://www.rcgroups.com/forums/showthread.php?2249574-Cleanflight-firmware-for-STM3…
-
Tests:
- Scan and attach
- Load program to flash
- Verify flash programming
- Start (Temporary flash breakpoint and execution control)
- Memory inspection
Target hardware:
- [x] 1Bitsy (STM32…
-
When trying to flash a too big binary the bootloader gets erased.
This is recoverable only through reflashing the bootloader via JTAG/SWD.
detected on stm32f3 (motor-control-board and can-io-board…
msplr updated
7 years ago
-
After a bit of tweaking, I ran into quite a severe baro issue on a BlueJayF4 board ([the FlyMaster clone](http://www.helipal.com/flymaster-fmf405-f4-flight-controller-bluejayf4.html)).
After I [got…
-
I am having trouble where uart2_irq gets triggered, but never acknowledged, causing the IRQ being immediately triggered again when it exits, with user code never getting chance to progress.
I singl…