-
The Vagrant installation went well and I see that everything is installed, provisioned and started.
However, I cannot connect to https://localhost:8080/.
The Virtualbox VM is in NAT mode and show…
-
Hi, I'm new to Lora server.
My question is where to set the application key and networksession key in lora server?
I have set up the packet_forwarder, lora_gateway bridge, lora app server, lora…
-
Hi there and thanks for sharing your code fork. I'm running with your feather example. I'm using a Adafruit Feather 32u4 with LoRa Radio Module MCU. This Feather 32u4 LoRa Radio uses the RFM95W 868/91…
-
Hi, I have a problem ,
when I use one node to test downlink ACK PER, everything works fine(PER about 1.5%), But when I use two or more nodes to test ,I found some problem(PER about 20-30%), Here is…
-
Can I use packet forwarder with SX127X modem instead of multichannel SX130X modem?. My setup is RPI board with HopeRF SX1272 LoRa module. I dont have SX130X and not interested on multichannel as well.…
-
Hello,
I have noticed that if I switch between 20 and 19dBm TX power, actually power jumps much more than that. Is there a way to make set 18-19dBm? I guess this is related to LUT in global_conf.j…
Kralg updated
7 years ago
-
Hi Petr,
I am able to successfully connect a few gateways and few end nodes with the server. Till now the performance is pretty good.
But what would happen if 100s of gateways and 1000s of end n…
-
Hello,
I have Lorank8 with my own devices with RN2483 Microchip 868 modules.
I use them with public TTN. It works fine.
Today I need to create private Lora network, so I tried to use gotthardp/lor…
-
Hi,
I have recently updated the lora_pkt_fwd program on one of my gateways and have used the "antenna_gain" variable to match my antenna's dbi. Since then I notice errors arising:
"ERROR: Packet REJ…
-
@danicampora reported the following issue:
> After starting the ttn-packet-forwarder, I check the logs and I get:
```
admin@mtcdt:~# tail /var/log/lora-pkt-fwd.log
INFO: Radiostream data is enabled
…