-
Hey,
I am trying to find the right settings for a Pololu Stepper Motor NEMA 11 Bipolar 200 Steps Rev 28×45mm 4.5V 0.67 A Phase for chopper configuration but even though I calculated the parameters …
-
- [ ] Design and Publish Schematics and EasyEDA link
- [ ] Add DIN Rail Mount for the PCB
- [ ] Add Gerber files
- [ ] Add Files for PCB Assembly
-
I have S109 drivers based on TB67S109AFTG. They need vcc=5V.
May I set VLOG JP101 to 3-2, (FD_5V) with Due ?
-
This is an issue for discussing how https://github.com/CliMA/ClimateMachine.jl/pull/1723 will work with the ocean split-explicit time stepping scheme.
The current scripting driver for ocean split-…
-
After waiting a long time due to the delay with the shipping of the covid-19, I finally received the item.
Then I installed it on my printer, following all the instructions I received from its github…
-
Hi, all!
I have problem with configuring Repetier firmware for such configurations.
I've set pins properly, and created Configuration.h, but it ignores motion on X,
puts motion on Y to X axis motor dr…
-
Hi,
some help requested:
I try tui use Marlin 2.x with Tevo Nereus (MKS Nano). Sadly I had some shortcut/smoke on X-Axis stepper driver a4988. No Idea if the nano board survived this.
It boot…
-
Hello, just mount my MKS robin ( Firmware 2.0.8). Drivers are TMC2208.
Microstep set to 1/16 (M1 High, M2 High, M3 Low). Stepper are Nema 17, 200 Stp/ with 20 teeth pulley . The step per mm is set t…
-
I was looking at this project after Joel's video today and noticed I had most everything on hand to start on this. The only difference is I have the Duet 3 mini 5+ and the 2+ expansion board for it. I…
-
So that I can test the G-Code on another PC, do I want to configure a dummy milling machine?
How can I do that?