-
Received product in fine shape. Started to hook up for testing and notice the driver replacement card at end of cable shows different VIN location than the driver mount where I removed the my driver…
-
Ordered for testing:
**Drivers:**
[A4988](https://www.amazon.com/gp/product/B07BND65C8/)
[TMC2209 V1.3](https://www.amazon.com/gp/product/B07ZPYKL46/)
[DM556](https://www.amazon.com/gp/product/B…
-
Buenas, queriamos saber si este modulo para controlar el motor paso a paso esta bien... https://articulo.mercadolibre.com.ar/MLA-728430892-modulo-a4988-driver-pololu-3d-ramps-cnc-arduino-cdisipador-_J…
-
Don't use this version on the Ender 5 pro. the z-axis steps are 2x on ender 5 pro (it has a different z-axis screw) so this version of the firmware will only move up 1/2 the correct amount, which of …
-
So, installed the board.
Steppers: 2pcs tmc2008, with uart activated, according manual.
3pcs of tmc2100 config as a4988 and [spreadcycle](https://www.youtube.com/watch?v=XLkIkG9IMd8) at vref 0.7v …
-
The reset of the A4988 driver (D1_RESET line) is connected to pin 61 of the STM32 discovery board which is used by another sensor. this prevents the Driver from working.
Please connect the D1_RESET …
-
Hello,
I have floppy disk arduino uno and ATX power supply.
The program on the arduino is working (tested with stepper motor and A4988 driver with Moppy Classic !)
and my floppy disk is powered and…
-
Hi,
some help requested:
I try tui use Marlin 2.x with Tevo Nereus (MKS Nano). Sadly I had some shortcut/smoke on X-Axis stepper driver a4988. No Idea if the nano board survived this.
It boot…
-
Any chance of some example code?
-
Had an issue where the motors would always spin in the one direction, regardless of sign of the move parameter passed. To make it work I had to remove the "abs" function in the speed calculations in "…