-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
Hello,
I am trying to update the firmware of my Creality V1.1.4 board using Sanguino as an ATMEGA1284p board in Arduino. I've managed to burn a bootloader to the board, using an Arduino Uno, with …
-
I lost a day, because I experienced frequent resets on serial reads.
This did not occur on the pins of Serial1 only on Serial and EVEN on an empty sketch without Serial.begin just with a short blink o…
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
Even when i try to run simple program like this:
`void setup() {
// put your setup code here, to run once:
Serial2.begin(9600);
}
void loop() {
// put your main code here, to run repeatedly:
}`
…
Spoja updated
8 years ago
-
When trying to run simavr the debugger fails stating load failed and no error.
My launch.json looks like this:
```
{
"version": "0.2.0",
"configurations": [
{
"t…
Con30 updated
2 years ago
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …