-
Good time! The topic of this question does not apply to the author's GPIO work. However, I have not yet found a solution to this problem, so I want to know if the author of the project had a similar p…
-
Board: BPI M2 Zero.
I'm trying to setup bluetooth.
The same command worked fine with 4.20.17
`brcm_patchram_plus -d --patchram /lib/firmware/ap6212/bcm43438a1.hcd --enable_hci --bd_addr b8:27:e…
-
Hi, I currently use an uart on the GPIO port with the original kernel (ttyS3). Is it possible to get this working on this kernel?
-
Not sure if this is perfect but it worked for me.
After hours and hours of trying to get it going on my Pi 4 I finally did.
Not wanting to break it I thought I would try on a fresh image of Raspbian…
-
# Equiva key-ble Smart Lock Integration with Home Assistant using keyble and keyble-mqtt
Hey there! Are you struggeling to integrate your eqiva smart lock into your smart home and control it using …
-
При переключении с воспроизведения со станции на "стриминг" на MPD, воспроизведение длится несколько (10..15) секунд, после чего MPD "умирает". В течение этих нескольких секунд другие клиенты MPD тоже…
-
### The problem
I haven't confirmed that the code does not work. I have tried a python program that uses the same UUID's as used here and it does not work.
This is the current module UUID's the sam…
-
we use rpi for voip and pbx and everything works fine except if we use the builtin wifi, then for some reason ping latency increases even on LAN and its more erratic when there is a voip call going th…
-
I was thinking about adding a button to the RPi GPIO wich would put it into access point mode for the configuration of the home newtwork(reset button).
Steps:
1. Python script to put Raspberry Pi in…
-
## Basic information
- Board URL (official): http://www.orangepi.org/html/hardWare/co…