-
Hello
What do you think it is possible to add PID position conttol of the mcm_xyz user from cnczone to this SDK. It auto generates code and project for IAR or Keil. From what i looked it is implement…
-
Imagine a scroll wheel that had the inertial scrolling commonly seen on multi-touch trackpads. But because the motion could be physically represented by the driven motor, the software could adapt to t…
-
Hi @vedderb (and others),
If I understood your post from https://github.com/vedderb/bldc/issues/63 well, changing configuration with _COMM_SET_MCCONF_TEMP_ shouldn't stop the motor (unless I set th…
-
Motors: 4x direct drive 3-phase brushless electric wheel hub motors (BLDC) with hall effect sensors, 350W nom., 800W peak
Continuous Current(A): 1 to 25A
Tire type: non-pneumatic rubber tire, …
-
In addition to exploring off the shelf 12VDC pump motors, it seems worth recreating a CPAP setup with 3D printed/off the shelf parts. Mark Rehorst's [printable blower](https://drmrehorst.blogspot.com/…
-
I'm attempting to use grbl to control a mill I've been converting to CNC. So far the stepper motor control has been painless, but I'm also trying to replace the bulky motor with a smaller, more powerf…
-
Hello,
I have hooked up a quadrature encoder to my BLDC motor in an attempt to get better startup torque and low speed control than with the default FOC sensorless mode. Unfortunately, I can't get…
-
I'm testing the torque control algorythm with arduino UNO, simple FOC shield (version 2.0.4) and BLDC motor (8 poles) with Hall sensors integrated.
When I launch the program obtain "Failed to notice …
-
Continuation of https://github.com/bipropellant/bipropellant-hoverboard-firmware/issues/32
Concrete information can be added here:
https://github.com/bipropellant/bipropellant-hoverboard-firmware/…
-
Steps to reproduce this error:
1) run BLDC tool, select "realtime data" tab, check "activate sampling"
2) send some kind of "high duty" command to the motor (e.g. duty 0.5, rpm 4000, current 3.0A, et…