-
Hi,
Just stumbled on this - i have 2 blinds for blinds2go and have been using a BroadLink pro to control them by learning the RF 433mhz remote buttons. This works OK about 80% of the time so found …
-
### The problem
Again problem with TUYA integration , binary sensors do not update status . after update to 2024.7.0 .
Motion sensor, door opening . After the first status change (motion detected…
-
### Prerequisite
- [X] Yes, I've read the readme completely.
### Cache
- [X] Yes, I've cleaned accessory cache and the issue still exists.
### Version
1.6.0
### Device Infomation JSO…
-
There could be an option to use the main slider for lamellas rotation instead of rolling up/down the venetian blinds. Currently the lamellas can be controlled only in the settings screen.
For peopl…
-
**Describe the bug**
When I set the "Observer Height" within the position-config dialog,
- the value survives when I close and re-open the dialog by pressing "Update"
- but the value will not be …
updor updated
7 months ago
-
### Description
See related discussion on https://github.com/WordPress/gutenberg/issues/22332
Cc @joedolson @alexstine
For the highest level of accessibility, the _visible label_ of a control …
-
##### Summary
I want to make a blindness statuseffect. So, I add an HUD that covers the screen. That works. But then, someone pointed out that you can disable HUD. Then someone suggested to make a …
-
I understand that Cover/Curtain module is now supported. Fork merged !
Is it possible to reverse the direction of motor motion (open / close) without changing wiring?
ie interchange OPEN & CLOSE…
-
### What happened?
Device pairs, but doesn't report anything until a second attempt at pairing.
After the second attempt, it reports its state, but doesn't respond to any of the actions.
OPEN/CLOSE…
-
The light intensity for lamps are typically lowered at night, to avoid blinding. It can be controlled by the clock or by a light sensor. It would be useful to be able to read/write settings related to…