-
Hi there,
i tried to get multiple BMSs connecting over BLE - but if a activate all (for me) relevant sensors with two JKs, the esp is getting very instable and crashes every 5-20 minutes. Goal would …
-
Please find attached a different RS485 protocol document, sent to me by IC GOGOGO Store for the BMS I bought from them.
I have also just received their RS485 Dongle.
The Dongle plugs into the BMS bu…
-
Hi @Casainho,
Long time no see! I hope all is well for you.
My ebike recumbent (based on your project with an old version of our display code) is still happily riding along. But I'm thinking a…
-
Some improvements
such as Total_charging_Cycle_capacity Ah -> kAh
![image](https://user-images.githubusercontent.com/26431172/228527066-13453e8e-e408-49ef-9d16-6c0a10d35452.png)
```
sensor:
…
-
My goal was to put both BMS I have (JK BMS HW v11 & v10) for a 16s setup over MQTT using the esphome-jk-bms tool.
To recap:
- 1 x ESP32 for JK BMS Battery 01 (jk-bms-bat01)
- 1 x ESP32 for JK BMS…
-
I'd like to raport that JK-B2A20S20P BMS works fine using JK02_32S, running on an ESP32 C3 board, connected via both BLE and UART.
BMS details:
JK-B2A20S20P
HW version: V11.XW
SW version: V11.28…
-
Hello. Has anyone run the disc version 2.3? At first I had a problem with uploading any batch, but I managed to do it for a while. now I have trouble starting it. when I connect the power supply, the …
-
Multiple RS485 modules on the same interface
-
@Insei Hi, Insei, I come to here again is to tell you that I got the TegraBoot messages from headphone port!!!
Its so cool~
It just happed after I bought a new USB2TTL connector to replace the …
-
I managed to get a connection and the code reports the voltage for each individual cell but for some reason I cannot het the basic data
eg : Volts , Amps , Capacity Remain Ah - they all show 0.000 va…