-
Using TPL's `arc(x, y, z, angle)` always exports GCode with many linear G1 commands instead of 1-4 G2/G3 commands? Can this be a config option so that GCode files are much smaller if that particular C…
-
Hello,
if there is a umlaut like ä, ü, or ö in any position of the path to the stored g-code file. The simulation of the path is not loaded / working. A Error message is not shown, because of that …
-
One thing I used in the old version (under windows) was the ability to be editing my GCODE in an editor and as I save the file, see the simulation window in CAMotics automatically update the part. Th…
-
Hi,
Can you modify the file selector for adding g-code files to a project to allow multi-selection? The fact this it's single select and doesn't remember the last directory/folder is somewhat annoy…
-
Kurtis Saiyo wrote:
> I was making mating parts that required some better tolerances. When I cut them out with the Shapeoko they were not working out properly after several iterations. What really …
-
With large tool paths it is difficult or impossible to position the slider bar exactly where you want it. It would be useful to have way to do finer grained positioning or position on a specific gcod…
-
1.
Could you please add a default rapid feed rate option to the settings. and make all G01 moves prior to the F command instant?
The program should assume it is at first X,Y at the start of the G…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
Using 1.0rc1 appimage from github. I wanted to use 3D surface feature in CAM workben…
-
Hi how can I import some gcode and change the tool. Every time I import any g code it dont recognize the tool.
Thanks
-
Currently the tool path optimizer is useless because it can only read gcode and optimize the path but cannot regenerate optimized gcode.
See #9.