-
### Describe the bug
There's currently an issue with F150 Lightnings on the Ford Q4 Harness/CAN-FD platform. This is specific to the Lightning as the ICE variants do not have this issue nor do the Mu…
-
Scenario:
Hardware:
RPI3, 4.14.22-v7+, /boot/.firmware_revision: v634741d4199871ab8bd5446a8e63b7e06c1885af (latest by today)
Device: 3D Printer, FTDI Fake Chip: FT232RL, 0403:6001, SerialNumber: …
-
Hi Timo,
thanks for the great library!
I want to build a binary switch bank and I'm currently unsure, what's the correct way to control the switches.
Should it be done by a pgn 127502 or by a…
-
WHen I try to execute the example code to read from analog I0.7-I0.12 I receive an error:
i2c_write: Remote I/O error
i2c_write: invalid len (4294967295 != 1)
It works for I0.0-I0.6 with no err…
-
RC Firmware must be changeable too.
Some limitations was added with RC Firmwares 1.6 and newer.
Output Power is reduced from 25mW to 10mW in CE Mode.
And
It should be possible to change CE to FCC Mo…
-
After we finally hit the flash memory limit in #923 and had to thank Thomas Basler for serving us a solution to save some code duplication and hence flash memory on a silver platter, we need to have a…
-
Hello Timo,
I tried to get the library up and running on my Arduino Uno, in debug mode. (I don't have a CAN board connected (yet)).
It behaved strange and hung after just 13 message frames. I made …
-
## Version of the moonraker integration
1.2.0
## Describe your setup
Klipper on Radxa Zero 3w, Moonraker, Fluidd, HomeAssistant Green
## Describe the bug
When attempting to connect to…
-
### Introduction
This issue deals with a topic that has been the center of multiple previous discussions and existing issues and PRs. This is an attempt at briefly summarizing the problem in order …
-
Hey George,
I love to see what you are doing here and I'd wish to try the system. But at my place we only got BMW's. These also have radar-sensors and adaptive cruise control.
What is needed to …