-
Hi @nisargjhaveri
I was debugging why it doesn't work with car despite it working fine in another and I came to conclusion that my headunit doesn't seem to send the accessory start request
I d…
-
We should expose the heating/wire mode for the NodOn SIN-4-FP-21 and Legrand cable outlet to Home Assistant.
Related PRs:
- #3364
- #3031
Concerns were raised that we would not conform to Home A…
-
Hello :)
Running hd-idle with defaults on an OMV7/Debian system with several Exos SAS drives connected via an LSI HBA (IT mode) card.
hd-idle is successfully spinning down the disks after 10 m…
-
# Describe the bug
sometimes a certain component is visible during edit mode but is not visible in test mode. I have found that this happens even when there is no other component in the same positi…
-
Hello,
I recently set up my first Shelly (Plus RGBW PM) device and flashed it immediately, loving the firmware so far, thank you for the great work!
I did, however, run into an issue that I hope…
-
Hello,
First of all I want to thank your very much for your contribution with this mod.
I was very disapointed when I realised this feature was missing from the game and I was so glad to see that…
-
Hi, thanks for all the work. I just started using this project and noticed that with the wired controller connected I can't set the Jet mode (at least while heating) on my AC (LG Standard plus, PC12SK…
-
For some reason, when I press on one of the proxies, in simple mode, another one randomly gets activated and then both of them fail until I delete the randomly activated proxy. I have screenshots If t…
-
According to Calico eBPF documentation "VLAN-based traffic not supported".
I need clarification: does this mean that if a Calico node is connected to a physical network via a sub-interface, the eBPF …
-
Hello,
I got an issue using tungstenite with native-tls feature. Sometimes when my project try to connect to a websocket with tungteniste using native-tls, the connection with client_tls panic with…