-
Hi,
I'm receiving below error when running evohome-Listener:
2021-02-15 19:52:07 | | ERROR | '1' on line 723 [Command ZONE_TEMPERATURE, data: '--- 037 I --- 01:204708 --:-----…
-
I can't upload this to my standard Arduino UNO (ATMEGA328P). If I set my board option to atmega328P (SWUART) It fails to upload immediately saying #error no baud rate defined. If I set the board type …
-
Hi,
is it possible to use an ESP8266 or an ESP32 with an attached CC1101 instead of the Arduino?
It would require a rewrite of the code I guess ( watchdog, io, timing, ISR or others perhaps)
but…
-
Windows 10, Python 3.8, NanoCUL with latest evofw3
running the install as per README.md
```
git clone https://github.com/zxdavb/evohome_rf
cd evohome_rf
pip install -r requirements.txt
```
an…
-
Hi,
I can't get evoGateway to run, I keep getting the following error:
pi@iobroker:~/evoGateway $ python3 evogateway.py
2021-07-04 10:03:06,880 [903] The schema file 'ramses_rf_schema.json' was…
-
Hi @zxdavb
Not an issue, but I'm the author of evogateway/listener - you may recall we had a brief chat a few months back in the automatedhome forum. I was wondering if you've had any further thoug…
-
I am using nanoCUL (Arduino Nano V3.0 ATMEGA328P + C1101 868 MHz), but no messages are coming even using minicom
> minicom -D /dev/ttyUSB0
nanoCUL is plugged to Raspberry Pi 4b.
For flasing …
-
Itho Daalderop also provides heat-pumps (water/water) which uses I2C communication as well similar to the HRU units.
Today the end-user can only control limited parameters (room temp, heating mome…
-
I'm seeing very few temperature broadcast messages from my TRVs (HR91s). Perhaps one or two per hour. Lots of temperature broadcast messages from the controller. What's the best way to try and work ou…
-
Hi,
First off, thank you for the effort in creating this script.
I am trying to send commands but have no success doing so.
My setup is a Arduino Nano with a C1101 board I've flashed the nano w…