-
Hi,
When compiling, I get following error :
'ADC2_GPIO12_CHANNEL' was not declared in this scope
adc2_config_channel_atten(ADC2_GPIO12_CHANNEL, ADC_ATTEN_11db);
Any suggestions ?
regards
Lud…
-
Hi, I'm using your motion sensor code and it works perfectly. However, I noticed that the board needs resetting every two days or it will go into a No Responsive state?!!!
-
## issue purpose
- パーツリストページを qiita に陳腐化する前提で記載 bot化?(週1アップデート)
- ちなみに、実体配線図用のfritzingパーツもかな~り充実してるよ~
- twitter bot
- パーツリストページへのリンク誘導 @gurezo
- チュートリアルページへのリンク誘導…
-
I am working on a project to illuminate a dark stairway with a smart LED strip, custom effect(s), using 2 motion sensors to trigger the LED strip in forward or reverse.
This seems like a common enoug…
-
Hi Claude,
thank You for Your software...
After successfully installation on Raspberry Pi 2B (raspbian-jessie-lite) the script working without any error message but also without any motion detec…
-
### Shelly device
SHSW-1
### Protocol (CoAP / MQTT)
CoAP
### The problem
Hallo,
beim Shelly 1 mit angeschlossenem externen Schalter (ext. Switch) wird folgende Nachricht im Protokoll ausgegenen:…
-
1. HC-SR501 draws more current than the Panasonic PaPIRs. Swap in PaPIR and collect information about discharge rate, number of transmissions and wakeups.
2. Power PIR sensor through GPIO pin and swi…
-
Not sure what you want from me but looking at serial monitor output.
=-=-=-=-=-=-=-=-=-=-=
WiFi connected
IP address: 192.168.x.x
Setup PIRpin = 1, 1, 1, 1, 1,
PIR Interupt>> 3
PIR Interupt …
-
I would really appreciate if you provide any support for a PIR motion sensor integrated into the software. Something like a callback function for every sensor trigger. The use case is that I could use…
-