-
selector endstop pin is defined reversed in fysetc 's hardware config file with the wrong ! symbol
**wrong (current version of file)**
`
Select the endstop you want depending if you are using s…
-
I am having trouble installing klipper onto my sv03.
Could I possibly get the step by step guide on how to install klipper on my sv03?
Thank you very mutch!
-
Hi @NARUTOfzr you have the Klipper configuration needed for these boards?
-
During the START_PRINT macro, we are doing a bed leveling. When that happens, if the total difference is above a key level, something like 0.4 mm, then it should cancel the print and echo why to the c…
-
### What happened
After a fresh RatOS 2.0.2 installation, the RatOS dashboard shows the following message:
_v0.11.0-248-gd725dfd3-dirty_
### What did you expect to happen
Not marked as dirty…
-
I adapted it to a voron v0 but after calibration(i make several error measuring the offset) maybe in production is interesting mark the center of the probe phisically for the calibration (you need it…
-
The pre-built firmware.bin is almost 9 months old. There are a number of issues that have been patched in Klipper. Uploading a pre-built version would save others a lot of time
-
### Requested feature:
I use some 3x3 patch for bed levelling from time to time and it's cumbersome to navigate from the main screen to the file.
I created a macro with Gcode, but macros cannot be s…
-
I get no communication when trying to connect via raspberry pi3b w/USB cable.
firmware uploads, 3V3 is green, firmware.bin renamed
tried 3 cables, all USB ports
removed, reinstalled klipper (ki…
-
Hello
Is there any update for these mods?
There are some kilpper-printers which can print in such modes.