-
reported by: @CloudyLex
the attached pdf shows the incident wmbasic SED, and the predicted total emission, for a hot wind around a star. The input script is also attached. This was run with r4683 …
-
Hi,
Having just received my V4 (bought from official store), I installed the driver (following v4 setup guide) and the dongle, for ADSB tracking. Checkout HEAD is 065e3d1a116f24c78622fd21c6c0d6efec…
-
In the comments of https://youtu.be/IzpBGvEF3WY, there were several requests to get `flrig` or similar integration in order to automatically detect and fill frequency, mode, etc. for log entries.
L…
-
-
We should decide if we should include the ATC position of GROUND (including a frequency) or if having positions as TOWER and CONTROL is sufficient for our operations. Do we have enough manning to incl…
-
Hello !
Thank you for the development and improvement of the firmware!
Is it possible to optionally increase sensitivity in the Satcom band?
-
Hello Everyone !
I just noticed a problem with this library and some libraries for the use of an ssd1306 and I would like to understand where this problem comes from and how it is possible to fix i…
-
Hi Dennis,
FMw is limited to minimum bandwith of 100khz. In some situations (noisy signal in near of) it would helpful to use a lower bandwith. Can you change it to 50khz?
Also i suggest to change m…
-
What I would like to be able to do is save a band, being a range of frequencies.
Right now I have a book-mark for "70 cm band low" and "70 cm band high", which lets me see visually where the 70 cm ba…
-
While running the receiver on a low-powered device like Raspberry Pi, I'm seeing a high CPU load. A signal gets sampled at a 5 Msps rate, SF 11, BW 250.
A quick profiling of a run-to-completion flo…