-
Can anyone help me figure out why my EBB2240 is displaying -93 degrees for my Hotend temp? Im using a Rapido hotend and i think its Pt1000. I have tried using these settings
sensor_type:MAX31865
…
-
I've been fighting SPI problems all afternoon.
I'm trying to get a MAX31865 working on OP Zero2 and seeing some problems with the SPI SCLK working correctly.
After reboot, my spimain.c code wo…
-
So, as you can see above, I finally managed to get the webapi going. I bought a new am…
rwr88 updated
5 years ago
-
Hi,
Currently i am integrating the ET-73 library in a ESP8266 project but the temperature isn't correct. At room temperature it's around 2 degrees off and at boiling temperature (Celsius) around 2,…
-
I apologize if this isn't the correct place to ask this - new to github
Would one be able to use a thermocouple through the adafruit board wired this same way?
Does PT100- analog = a thermocoupl…
-
### The problem
I recently upgraded an older version of ESPHome to 2024.7.3 and today I hopefully upgraded to 2024.8.0, but my problem is not solved, that I cannot compile the yaml file that contains…
-
Problem with temperature reading on THR36.
If I use the same thermistor and connect to Monster8 v2 instead CAN board THR36 reading are valid.
Difference between reading by THR36 and Monster8 is mor…
-
I just replaced my SKR Mini e3 V1.2 for V2.0. Powered on the printer and validate everything was running. Then I downloaded and updated the firmware for BLT from https://github.com/bigtreetech/BIGTREE…
-
Good day, everyone.
I have a PT100 temperature sensor with amplifier board, which I have ordered from E3D-online (https://e3d-online.com/collections/upgrades-v6/products/v6-pt100-upgrade-kit). Now …
-
Can someone explain in very simple terms how to "cut the jumper" so I can run a PT100 through an AD597K board?