-
* KOReader version: v2020.10
* Device: Remarkable 2
#### Issue
Koreader does not start on Remarkable 2.
* screen freezes
* `systemctl start xochitl` brings it back to normal
#### Steps …
-
Hi,
I could not understand what you mean by these:
-> B8 has to be connected to the same ground as the Pogo GND pin
-> The ID pin on Pogo connector is not connected to anything
In the pic…
-
I'm sure I'm doing something wrong. Usb-Armory MKII in SD bootmode with no SDCARD present.
Trying to load armory-ums so that i can flash debian eMMC image. Running on an ubuntu 20 VirtualBox vm (ho…
-
OS : ubuntu 1604
uuu: libuuu_1.2.135-8-gb8da38a
Build in config:
Pctl Chip Vid Pid BcdVersion
==================================================
SDPS: MX8QXP 0x1fc9 0x012f [0x0002…
zcily updated
4 years ago
-
Hi everyone,
sorry I'm a new user of MX8MQ and in general of this kind of micro. I have to flash Linux on SD card from a widows host PC.
I'using uuu_imx8mq_com_4.14.98 package and this is the result…
-
ISSUE TEMPLATE ver. 1.1.1
BE CAREFUL!! FOLLOW THE RULES AS FOLLOWS, OR YOUR ISSUE WILL BE `WON'T FIX` ANYWAY
STEP 1. Check what you are suffering from :
- I'm us…
-
Hi, I'm trying to burn u-boot on i.MX8MM EVK emmc using Ubuntu 18.04.4 LTS on host machine. It's returning the following error:
Wait for Known USB Device Appear...
New USB Device Attached at 1:2
…
-
I am trying to use the example code located in /python/test/protocol1_0 to get the motor to move. Unfortunately, it does not work. My MX28's are connected to a CM700, and the CM700 is directly conne…
-
Hi customer met LIBUSB_ERR0R_TIMEOUT during downloading the roofs.tar.bz2 which is compiled with bitbake fsl-image-validation-imx. but smaller rootfs.tar.bz is working well.
below is the uuu log..…
-
Hi @OpusK,
I am trying to get myself going again on the updating of some of Hexapod code base, to now use this library instead of Dynamixel SDK. The main board that I believe Trossen Robotics will…
KurtE updated
3 years ago