-
Between the spacer dimensions in `Mechanical/Small/Module/c1_design_space_ref.pdf` and the PCB limit area dimensions in `Mechanical/Small/PCB/c1_pcb_concept_design_ref.pdf` there appears to be an "off…
-
Getting a 60-pin card edge connector for the Famicom is pretty easy, and I have a few. The Sipeed Tang has enough GPIOs that it should be able to handle it. Has anyone considered an option of buildi…
-
Hi there,
Regarding my project:
- Repo: https://github.com/OpenGammaProject/MicroFC-SiPM-Carrier-Board
- Kitspace: https://kitspace.org/boards/github.com/opengammaproject/microfc-sipm-carrier-boa…
-
Currently design rules are pre defined
If you make a panel where people can defile new set of design rules and save them (like what we have in pcb design softwares) it will make siepic a generic pack…
-
For 2x Sony MPF920-E drives I have, the power connector is high on the pcb. It is needing alignment towards the bottom of the pcb to be a simple direct plug-in solution. Slight lifting of the floppy d…
-
**Is your feature request related to a problem? Please describe.**
_A clear and concise description of what the problem is. Ex. I'm always frustrated when [...]_
Persons new to engineering must lear…
-
As per title, would be good to have 3D STL of the PCB or layout file as to to be able design a case
-
I tried converting one of my designs via Gingerbread, and noticed that the drill holes seem to be converted perfectly, but the size of the F.SilkS layer is smaller. The height of the design is about 6…
-
can i get pcb design?
-
Hello!
I orderd two Pachinko PCB/panel sets at Pusherman(v1.0). The build is finished by now and everything works.
I just wanted to give some Feedback on the PCB design:
- D4 and D5 do not have…