-
This arose [in the forum](https://forum.micropython.org/viewtopic.php?f=20&t=8395).
Unlike Pyboard 1.x there are no firmware builds available for the D series with threading enabled.
-
Hi.. Thanks for the code..
A question, do i need to get uninverted SBUS signal before connect it to Pyboard RX (UART)?
-
i have the following modest prompt
`/home/phil/projects/pyboard>`
when I try to type the following command
`cp /RED_PYB/flash/color.py /RED_PYB/flash/main.py`
The cursor doesn't start a newline b…
-
Hi,
in the present config, I really like the idea that two skin board can be added side-by-side. This allows to add a single board on the X pos, but keeps the access to buttons and LEDs open.
Since …
-
I know it's a longshot, but it could be useful for assignments that have very well-defined input -> output transformations. I'm in talks with @tj90241 about seriously writing Compytition, so if we eve…
-
After installation, I ran in to the py3k_compat error, which was resolved by changing `collections.Callable` to `collections.abc.Callable`, however, this error does not go away:
`$ rshell -p COM5`
…
-
In PowerShell:
Without `-p` option: **0.76elapsed**
time rshell --quiet 'exit'
0.00user 0.00system 0:00.76elapsed 0%CPU (0avgtext+0avgdata 5140maxresident)k
0inputs+0outputs (133…
-
After #1, design the chassis for DUObot. Needs to mount motors, pyboard/shield and battery pack. Making it relatively small is preferable (similar to BeagleMiP).
-
Hi,
I try to use the v2.0.1, and it always shows no setup found.
but I can use the…
-
Hi, how hard to make this code run for MicroBit?
PyBoard too expensive for me.