-
https://github.com/NvChad/NvChad/blob/682b023fb36834fda744c9b488d9227c66be7c29/lua/core/default_config.lua#L38
https://whichiscorrect.com/riden-or-ridden/
overriden → overridden ?
-
Hi,
Thanks for sharing this FW :)
I have a RD6024. Do I need a '24 version of the FM to make it work, or can I use the nearest version? Given there's a file for each one, I suspect the latter an…
-
----------------------------- Delete below -----------------------------
**Reminder: If your issue is a general question, starts similar to "How do I..", or is related to 3rd party development kits…
-
Hi, could you please give some instructions for setting this up?
- Is the yaml for home assistant?
- Do I only need to add this to the configuration.yaml and then the device is integrated in HA?…
-
Hello everybody.
I've got esp-homekit-sdk from Espressif and I built the example "lightbulb".
It works fine. I can change led status from may Home App.
Now, I want to switch on/off the led also b…
-
Unless I am mistaken as of now the "Full width" option is on a per-page basis.
Personally, I want every page to be full width by default and have to remember to check this option on each page I cre…
-
### Prerequisites
* [x] Model name of your Devices
TS0601 by _TZE200_b6wax7g0
* [x] Output from Home Assistant Device Diagnostic from BT
```json
{
"home_assistant": {
"installation_typ…
-
### Tukipyyntö
OUTIssa tarvittaisiin jo olemassa olevaan raporttiin 363 **Varaukset yhteensä** -sarake. Uusi raportti käy myös, jos vanhan raportin muokkaus ei ole järkevää.
### Jotain muuta?
"Vara…
-
When the 6012P is configured at high-current mode (12A range), the code goes wrong when it tries to get a reading where the current is higher than 6A. Is there something going on with register #20?
-
All heading should be clickable and should have a hover title that says Go to Top.
Some headers have this, some do not.
The headers that do not have the `` tag correct, but the tag is over-riden or …