-
They are using a Type T thermocouple. I asked them to go through all of the thermocouple types in the software supplied with the thermocouple reader, but none of them matched what they were getting wi…
lo-co updated
8 years ago
-
The junction temperature sensor should be thermally coupled to thermocouple junction and isolated from any heat sources. If the T100 plugs directly into the host computer USB port (https://github.com/…
-
I need to replace my cartridge heaters, does anyone have a source for them ? or if someone knows the exact spec I can just source them.
after a terrible jam that left my head full of ABS, I need to r…
-
Protect for the condition where thermal runaway due to fault in sensing heat - may need a debug flag that turns this off when running without mains plugged in
-
Hello,
I have four thermocouples and I'm working with your code to read the four temperatures but I have some problems when I try to read the next thermocouple.
Have you tried to connect more th…
-
```
What steps will reproduce the problem?
1.Yoctopuce thermocouple device connected
2.Open Artisan and press ON
3.Following error displayed: YOCTOtemperatures() YAPI shared library is missing
(C:\Pr…
-
Would it be possible to retrieve both temperatures that the thermostat monitors?
They have a thermocouple "probe" that usually gets the temperature of the floor. There is also a sensor in the th…
-
There's another [fork]() of Klipper which has added ADS1118 support, for use on Replicator 2 clones as a thermocouple amplifier.
I think it would be nice to have alongside #103, and the ADS1118 feat…
-
Hi
I'm trying to install your max31855's module to use two "k thermocouples" on a Raspberry pi 3 under Raspbian 10.0.
The installation seems to be ok...
When I call it in Python 3 :
```
>>> imp…
-
One wire temp sensors not reliable enough. Also clear that need battery and cell service.
Got the following:
Thermocouple
- https://www.adafruit.com/product/3245 - K thermocouple
- https://le…