-
Hey there,
got one TMC5130 v1.5 Board, running a Nema 17 motor (200 steps/rev) via SPI. I first tested ramp mode 0 and when I set xTarget to 200*256 (256 = stepping) the motor did a 360° turn. In vel…
-
i converted uart_chained_drivers.ino to this tmc5160 library.
but im unable to get it to function correctly.
so far i can get it to find each device and switch the nao pin to find the next driver …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Firmware not compiled with USB flash drive support for BTT SKR PRO v1.2
, but find out …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
While moving Z axis extruder moves together and while moving extruder no stepper moves.
Ju…
-
Hello,
I am struggling to configure the standard TMC5130-EVAL board to run a stepper motor with full steps or half-steps, but so far I could not do that.
Is it somehow "nailed" that the standard E…
-
**Update:** @vertigo235 set up a Discord server for this issue, if you'd like to discuss/work with people on the problem. Here's the link: https://discord.gg/hYUjSnW
This issue has been closed afte…
-
Please, before you create a new question, please make sure you searched in open and closed issues and couldn't find anything that matches.
Will there be a stealth Mode known from the mk3 in future …