-
In the next revision, could you provide support for more advanced stepper modules?
this would require that the three config pins have a way to set them individually or have them connect to spi (for…
-
Hi there, so far I was not able to run TMC 5160 bigtree 1.2 using rampmode, full SPI control. I'm using a 5160 with esp32, with a 3A stepper nema 23, I could achieve a High torque with normal STEP/DIR…
-
Do you know how to make the Fysetc Mini 12864 to work with the TH3D-EZBOARD LITE using their unified firmware?
-
**Is your feature request related to a problem? Please describe.**
Please help me proof-test these examples Marlin configuration files for CR-10 and CR-10S that is submitted for upstream inclusion:…
-
Hello , did somebody tried to use this library as motion controller mode.
Meaning that sending speed and destination via SPI and chip has full control motor ?
thanks a lot.
-
**Describe the bug**
Hello, I tried to use ros2_canopen to control a motor, following the instruction https://ros-industrial.github.io/ros2_canopen/manual/rolling/application/trinamic.html
However, …
-
I have encountered a problem, I use the latest marlin firmware and 5160 is OK on my motherboard. The configuration is not changed, only the drive is changed to 5161, and the information displayed usin…
-
A prototype of the MRR ESPE board, which uses 2 x 74HC595 shift registers to implement I2S stepper stream for the ESP32, is out. Most of the board design is based on the MRR ESPA board (many many less…
-
Hello there,
currently I am working on a Arduino project, with an arduino and a TMC5160 Stepper Driver.
The goal of this projcet is, to let a Nema 23 Stepper turn in both directions. Easy as that…
-
Temmuatlut thanks for the hard work on this library.
I'm working with the 5160 BOB and while testing settings to evaluate what I want to use on my 3d printer I noticed some of the commands for 5160…