-
I have a HY 1.5K Spindle that works perfectly. I can start and stop the spindle from io sender without any problems. From time to time when i have to abort the program the spindle does not stop. I…
-
```
What steps will reproduce the problem?
1.Loaded latest AR-P. It loaded perfectly but the front panel display
permanently shows "boot"
2.
3.
What is the expected output? What do you see instead?…
-
```
What steps will reproduce the problem?
1.Loaded latest AR-P. It loaded perfectly but the front panel display
permanently shows "boot"
2.
3.
What is the expected output? What do you see instead?…
-
I have a GRBL connected to a VFD then my spindle. Recently the gcode I send to the GRBL is working except my spindle isn’t turning on. I can control the spindle with my VFD manually. There are no loos…
-
When flow sensor in actual setup (long cable, VFD idling) the liters constantly count up, randomly it stops tough.
 and [onefinitycnc forum post](https://forum.onefinitycnc.com/t/best-way-to-e-stop-spindle-and-vfd/10792).
#### E-Stop…