-
Rev1 problems...
- logo2 ref on silkscreen
- the footprints on one half are correct, the other half will result in wiring harnesses that are backwards; footprint needs to be 180'd
- there is prec…
-
- Cad files and blueprints for the cabinet should be made available
- Assembly instructions should be with them
- A list of all parts used would be useful too
Most if not all of these are in the …
-
Payloads 1 - 4 on mainboard v01 and v02 are designed with a SPI/I2C/UART interface that accommodates my [ADC breakout boards found here](https://github.com/maholli/XTB) which have been used for a mult…
-
System setup:
Bosch CS6800iAW/WLW176i heatpump
Bosch controller UI800 (integrated in heatpump unit)
Bosch WLAN module K30RF
Bosch mixer MM100
System: 3.6.4 (ESP32-S3)
Issue:
The CS6800i has t…
-
Good morning
I was working with my board and it blew out. Was running 9v thru it
-
### Context
At comp something shorted on the rear power distribution board. It now no longer requires the reset button to be hit to be active, and upon GLV turning on it momentarily turns on multip…
-
Current corner servo-to-board connection uses 2.54mm pitch DuPont connectors, which provide no mechanical connection/locking aside from friction and the spring tension of the female connector. The use…
-
Hi,
I've searched for this shield, but am unable to find it. Do you have a link for purchasing or is the schematic available for review?
thanks,
Steve
-
Hi,
thanks so much for your work. It's really helpful. I have one question.
Is there a way to display all different classes in one ground truth mask?
I have a dataset with 8 classes and in ever…
-
There are 200 letters in total: five rows of 40 characters. Each character is driven by a 5-wire unipolar stepper motor which will be run as a 4-wire bipolar stepper motor, leaving the center taps unc…