-
Suggested enhancement
### Description of the setup:
* Device: Redpitaya
* SD card image: Alpine 3.6 but also applies to 3.8
* Application: WSPR
### Description of the problem:
If the ws…
-
Hi again Pavel, the following is a continuation of a post I made awhile back
https://github.com/pavel-demin/red-pitaya-notes/issues/629
Thanks for your advice, which I followed and I was able t…
-
I am using Alpine SD card 3.6. The redpitaya is hardwired to my pc which connects to the internet via wifi.
The gateway address on the rp is 192.168.1.1 but my wifi router ip is now 192.168.1.254 …
-
Hello John,
can you add all WSPR Frequencies as mentioned in the following post:
http://wsprnet.org/drupal/node/7352
I made some good spots on alternate 80m and 60m frequencies by entering it manu…
-
Hi Pavel,
Question...I was wondering if your multi-band WSPR receiver/decoder could be converted into a multi-band FT8 receiver/decoder. I see you use 'wsprd' to decode captured audio. I think th…
-
Thanks for a very useful program. My Pi 3/RTL-SDR is running very nicely, listening on 20m and reporting up to wsprnet.org.
I was wondering if you could add an option to run rtlsdr-wsprd for a spe…
N5RWK updated
7 years ago
-
The WSPR spots are not cached when wsprlive.net server is down.
This can be implemented similar to the caching for wsprnet.org.
-
Hi,
Whilst using other Kiwi SDR's on sdr.hu it sometimes surprises me that signals I'd expect to see are not present. Often this is simply because it's night time where the SDR is located.
Would…
G8JNJ updated
7 years ago
-
when doing so only 4 files appear on sd card
boot.bin 1,59MB
devicetree.dtb 11,8kB
uEnv.txt 319 bytes
uImage 4,67 MB
total 4gb sd card is said to be only 11,5MB big
how to proceed, pleas…
DK8FT updated
8 years ago
-
Hello,
I think that on Line 33 it should read "M" instead of "N" , but it works anyway.
The calculation of distances and bearings is sometimes strange. The bearings are more or less ok, but the dist…
ghost updated
10 years ago