-
Dear all
I made a test long time ago to run 6-axes from an Arduino Due and after a little bit of fiddling around I got it to work. The version I started to work with at that time was a807727d7 "089.0…
-
I implemented a close loop to check the position on axis with micrometer measure (fagor CX optical line)...so at the end of a cycle I can check really machine position and tinyg2 position G53.
I'm ch…
-
My Due hangs when sending multiple commands to board. Single commands work, but all responses are slow (e.g. $ needs alsmost 2 sec.)
On stable 87 everything works, but after upgrade problem occurs.
…
-
Hi!
I have a C-Beam setup with an Arduino Due, gShield and 2A motors.
When I run [this old version of the firmware](http://synthetos.github.io/g2/), the power management seems to behave correct. T…
-
I have loaded latest G2 edge firmware build 100.15 and found that board cannot be used in Chilipeppr TinyG workspace. Connecting a terminal has shown that board responds to various status commands ($,…
-
This is my configuration in g2core.h:
```
/****** COMPILE-TIME SETTINGS ******/
//#define __TEXT_MODE // enable text mode support (~14Kb) (also disables help screens)
//#define _…
-
I have been adopting OpenWRT/buildroot for this kind of bare metal development. It gives a versatile build system that is able to cross compile software for microcontrollers just as one would do when …
-
I'm trying to figure out if I could potentially use these, but I can't find anything about how they work. The LinuxCNC description says the machine position at probe switch is stored into parameters, …
-
Paraphrasing from a discussion with @wolfmanjm in Oct:
@wolfmanjm said
Maybe it is time to reconsider a special LW only command that sends a raster line at a time?
This will require some thought …
ghost updated
7 years ago
-
Title says it all.