-
Hi All
on APM/Copter 3.2.1 when running Telemetry/GCS as primary flight control with a RCTX setup to allow launching from the tablet(rctx=stab mode with throttle 0)
a loss of autoguided primary f…
-
I finally got my milling machine set up and am trying to get the homing sequence worked out correctly. First, I have only a single limit switch on each axis as follows:
X-axis moves negative to activ…
109JB updated
9 years ago
-
Currently, the software does not have a sensible concept of a "print start position", with the user responsible for manually jogging the print head to a sensible start position and then hoping that th…
-
Default behavior for an "Abort" command should be to de-energize all heaters / lasers / or other energy-emitting loads to produce a safe shutdown state. I would recommend switching all FETs to an off-…
-
I am trying to upload T3P3 firmware on duet board. Printer is working fine, but I have just one problem. After pressing home all axis on Pronterface all axis are homed corectly, but when I send M114 i…
-
I maintain a shared printer that is frequently used by inexperienced users. I am trying to enforce the rule that you only print when the extruder and bed are at their set temperatures. I use this rule…
-
After 'lots' of work (more than expected), I've completely overhauled the g-code parser in the development branch of Grbl. Grbl v0.9e should be 100% (or near) compliant to the g-code standard. This wa…
-
I think the big red button that shuts down all movement immediately is a must for the next release. (Have you ever watched a faulty program break your cutter and you couldn't react because the mains s…
-
I wanted to start a thread to discuss how homing cycles should work and be invoked. This is actually a complicated topic as there is no guidance in the Gcode spec and everybody does it differently. Pa…