-
Hi,
I started with red_test example, SOEM on linux and I have one Beckhoff slave EL9800, and got unexpected output regarding the work-count while running the application. If I am not wrong, workcoun…
-
HI,
I try to run delta driver asda-a2-e but without result.
I can see all device (ethercat slaves) i can read write thrue CoE, but when I run linuxcnc, dmesg shows
problem with syncmanager for SM2…
-
Hi.
I'm using SOEM on Linux for setting the output voltage of a Beckhoff EL2004 device [1].
./slaveinfo -sdo reports
```
Slave:4
Name:EL2004
Output size: 4bits
Input size: 0bits
State:…
-
Hello Guys,
I'm trying to using SOEM 1.3.1 for driving a servo, but after run simple test, the servo (ethercat slave) cannot go into op state, it stay in safe op state without error.
Following a…
-
Hello all,
I am very new to EtherCAT so I'm sorry if this may seem trivial.
I had been working on trying to configure an EL2535 and it would not enter OP mode. I saw a similar issue where it was r…
-
I have a problem that the servo is not working when I define 4 objects in the Rx PDO. Three objects is ok. I made a double check using codesys and then it works with 4 objects. Any idea what can be th…
-
Hi ,
I have successfully compiled and installed SOES and SOEM in two different system(ubuntu 16).
How to check SOES and SOEM ?
******************************************************************…
-
Hello all :)
first of all, I'm sorry, if my question might be silly or trivial, but I'm pretty new to the world of EtherCAT.
I'm trying to controll a Festo CPX-FB37 bus node (https://www.festo.c…
-
I use soem to control some ethercat module well,But here I'v got a IO Device that can not mapping config correct, the device does not have a default configuration, at least does not have enough CoE th…
-
Hi SOEM devs,
I've got a slave here which does not change from PREOP to SAFEOP in the slave_info program. Actually, it is the [device](https://catalog.weidmueller.com/catalog/Start.do?ObjectID=1334…