-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
Spinning propeller blades went from having a round contour and being textured to being simple untextured triangles, see before and after:
 and I'm not sure why. While examining the [log](…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…