-
There are a few really long paths in mor1kx in Kasli.
Happens with 2017.2 and 2017.4.
Happens in both mor1kx cpus (comms and kernel).
We used to run the Spartan 6 mor1kx at 83 MHz on pipistrello to…
-
Clocker v1 arrived.
There are some minor issues:
- [ ] Use the 712RA barrel connector (not the long barrel L712RA). Same footprint. Just shorter barrel.
- [x] voltage setting resistor should be 33k…
-
Multichannel gateware servo to control an Urukul DDS amplitude based on a Novogorny ADC input.
Design and implementation funded by Oxford.
Code development: https://github.com/m-labs/nu-servo
A. …
-
@gkasprow I'm trying to get the HMC830 on Kasli up and running.
I modified the firmware to dump all registers (apart from the VCO subsystem) 3 times: once after power on reset; once after configura…
-
This occurs on the Sayma1 board we have on the HK server.
-
The uTCA chassis which is developed for another project (related with video processing) is coming soon.
The main difference is that requirements are slightly different. Main differences are:
- embed…
-
Moving from m-labs/artiq for now as this may be a hw issue.
@gkasprow:
- I remove the jumper on the programming connector to re-enable the RTM Exar chip, but left the 2V and 4V rails disconnected.…
-
@gkasprow measurement setup:
- Booster ch0 driven by a synth at 200MHz. RF power is either -8dBm or -11dBm input
- Measuring the output power on an RF power meter using -45dB high power attenuator b…
-
- Rotate SATA connector
- Have I2C and UART signals in the same bank (each of them)
- Switch all components to our standard library
- Switch U1 to nonBGA version
- Maybe [Bigger heat sink](https:/…
-
```
__ __ _ ____ ____
| \/ (_) ___| ___ / ___|
| |\/| | \___ \ / _ \| |
| | | | |___) | (_) | |___
|_| |_|_|____/ \___/ \____|
MiSoC Bootloader
Copyright (c) 2017-2018 M…