-
Per https://community.platformio.org/t/request-to-add-platformio-support-for-earle-philhowers-arduino-pico-raspberry-pi-pico-sdk/22285.
As simliar to e.g. STM32 and AVR with `board_build.core = ..`…
-
- [x] Create manifest (https://github.com/Halium/halium-devices/pull/35)
- [x] Boot image and system image build successfully
- [x] Device boots into rootfs, `usb: Manufacturer: GNU/Linux Device` ap…
-
**Is this the right place for my bug report?**
This issue seems to be firmware-related, as the clocking is done through it.
**Describe the bug**
Setting `arm_freq` beyond 3000 works fine, but `vc…
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…
-
I'd be really keen on an Ethernet variant of this for automated setup. My ATE experience is that Ethernet works better, long term, than USB, and doesn't require any host-side drivers. Perhaps the 32u4…
m1geo updated
9 months ago
-
I'd like to try out the code for the BTT SKR E3 Mini v2.0 board that's being worked on in #2. I understand that Eclipse is grblHAL's IDE of choice but I'd prefer to use something that's less of an in…
-
**Describe the bug**
Driving motors on beaglebone blue generates a "segmentation fault" after one or more iterations. After the fault, the beaglebone does not accept new commands. A sample size of …
-
**Describe the bug**
fwdupmgr security reports that SPI write protection is disabled, when it should be enabled. Additionally, CET OS support is marked as "Not supported".
**Steps to Reproduce**
…
-
### Describe the bug
As detailed by @lgeitner in the thread starting at https://github.com/raspberrypi/linux/pull/6144#issuecomment-2349489287, the MeteoPi application which requires UART access seem…
-
Steps to reproduce:
Just update.
Was able to roll it back with Timeshift in compatibility mode, rebooted and updated again, same thing happens.