-
Hi all,please help me connect my 15w laser to CNC 3018
Sorry for my English :)
My board is woodpecker 3.2 updated to 1.1f,Software laser grbl.
My laser:
Output wavelength: 445nm~450nm
Output Powe…
-
I have a question, do you think it’s possible to add support for more versions of the Arilux controller?
Also I think these are the same as the Magic Home controllers?
Here’s the version specific in…
-
Lately I've been thinking quite a it about how versatile the BeeHive could be even for remote field work, moving the applicability from just the lab out into the field.
**Battery**
On obstacle is…
-
Find a commercial transformer suitable for this application:
- at least with three windings
- THT, SMD ok
- small form factor
-
> measure the voltage and thus estimate the battery charge/state, and warn the user/software that charging of the battery might be needed, or there is another problem with the battery (see: http://www…
frnhr updated
6 years ago
-
# Contexte
Je souhaite piloter un feu rouge en 230V. J'ai 1 phase par ampoule (C'est des LED rassurez-vous) et 1 neutre commun.
# Problème
J'ai besoin d'une carte de commande pour piloter ces feu…
-
also document diode mod for older revisions
-
Hi looking at this its reallygood I wouldlike some help on a couple of pieces. A little background I have a clone pcb an with it being a lottery on wether you get genuine parts or even a working one I…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
Stepper motors are noisy/vibrate at low, medium and high speeds (30mm/s, 60mm/s, 80mm/s, 120mm…
-
I made the pulser PCB circuit. I upload the code and set positive and negative voltage to 50 through serial interface. I was not able to connect to AP mode.
I supply 12V input and 1kHz square wave…