-
Greetings,
I recently had bought an MPCNC board just before I saw a post about this board https://github.com/bdring/4_Axis_SPI_CNC. I'm using the board to control a diode laser and machine I built.…
-
Let's coordinate the Marlin 2.0 RC1 release and track remaining work for this first release candidate.
### AVR
Board|MCU|SD Card|LCD|TMC SPI|TMC UART|EEPROM|WiFi|Max6675|Neopixel
-|-|-|-|-|-|-|…
-
please help me im a new to cnc so i got this problem with gcode when i try to send this gcode to universal gcode sender..it gives me an error "an error was detected while sending OS30: error:1" i…
-
Hello!
I have a problem with my laser I cannot figure out for long time.
I have a laser which works (burns) when I switch it on without any control.
When I connect the laser to CNC Shield and start…
-
I bought SKR 1.3 and TMC2208 UART all from BIGTREETECH and all seem to work fine with Marlin Fix 2.0.x
The only issue that the extruder wont rotate unless I disable Linear Advance in marlin. I had …
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
Please someone help,
I have spent many hours troubleshooting my motors:
I'm trying to use 2 different kinds of motors, both are nema17, i am unable to get either to work, i've been trying to chang…
-
Hi everyone, I built an MPCNC to which, I connected a CNC Shiled with DRV8825 driver.
Following some tutorials, I set the microsteps of the card to 1/32 (all three PINs with jump) and I entered the o…
-
hi guys can someone help me how to configure this grbl (https://github.com/bdring/Grbl_Pen_Servo) to work with my servo for up and down movement? im using windows 10 and ugs
my hardware is arduino…
-
I am currently trying to get grbl Mega 5X running on an Arduino Mega + Ramps 1.6 setup and am hopelessly lost in finding an initial issue.
I have flashed the software onto the Arduino without chang…