-
Hey,
If I add fe80::2 to RIOT ethernet (ethos) using "ifconfig add fe80::2", then add fe80::1 to the ncache for that interface ("ncache add fe80::1"), ipv6 outputs this:
```
main(): This is RIOT! …
-
```
It seems that the Dummy Extended Address, named LocalIeeeEui64C, has
been included for micaz, but not for intelmote2.
As the /opt/tinyos-2.x/tos/chips/cc2420/control/CC2420ControlC.nc
file wires …
-
Hello everyone,
I am now in a starting phase of a 6lowpan project.
I did exactly as the instruction from
http://processors.wiki.ti.com/index.php/Cc26xx_sw_examples
The compile was done and I can …
-
Hi, I'm Mike Grusin, one of the engineers at SparkFun Electronics.
We're about to release some breakout boards for the RFM69 module in the HCW (high power + compact) variant. We very much like your R…
-
When testing #4144 with a border router setup, I set up the interfaces as follows:
```
ifconfig
2015-12-23 15:00:24,042 - INFO # Iface 5 HWaddr: 65:b2 Channel: 26 Page: 0 NID: 0x23 TX-Power: 0…
-
```
What steps will reproduce the problem?
- try to send packet with length 15 bytes and more of payload without
RF230_SLOW_SPI defined or slightly more bytes with RF230_SLOW_SPI defined
What is th…
-
I am running 6lbr on CC2538DK+enc28j60 and make CC2650STK joins. I can see CC2650STK trying to send MQTT packets but it shows nothing on IBM MQTT quick start service. I think I need to do some NAT64 s…
-
Hello,
I flashed 6lbr mainlatest to CC2538 with CETIC_6LBR_ROUTER. So now I can't reach the webpage.
I flashed with debugger, is it necessary that the NVM must contain legal information?
What is the …
-
Hello guys. I've been struggling to get mesh nodes to send stuff to 'external' IPv6 addresses (e.g. something that is neither the wsn prefix nor the eth one.). I've experimented with 2 setups.
Physic…
-
I think this is why i can't see sensors. But I don't know what to do with it.
I am using the platform cc1120