-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have up…
-
This is a clean-up of #590.
* #590
It will be good to have a list of known-good firmware to test hidapi. It is also good to have virtual HID device for CI.
-
## Steps to include:
1. visual inspection
2. DMM check for likely (fine pitch) and especially severe (power to ground) shorts
3. Apply power and make sure nothing blows up or gets really hot
4. Lo…
-
Hello, I bought I2C SSD1106 which is working with other codes but when I upload that code with configuring A_config the display behaves dumb and It refreshes every 10 seconds.
here are my circuits:…
-
I try since this moorning to make it working with python2.7 or python 3.0
Linux distro : Parrot Debian based
Hardware : NXP LPC43xx
I compiled flash and can flash the board in DFU mode, but o…
-
Hello, my question doesn't aapply to any particular os version etc. A couple of firmware upgrades ago on the steam deck controller added a new usb interface for the built in controller, a usb to seria…
-
I try to boot Cubieboard 1 with initramfs, but system doesn't start. MMC doesn't show in /dev and manual created node doesn't work (when try to mount created node:no such device or address). This same…
-
Hi,
Thanks for your useful library.
I am trying to write my sensors data on file, but there is a long delay after each writing block (256 bytes), So I have to wait for the next ready(Done) from Ch37…
-
./ola/OlaClientTester -l 4
olad/OlaDaemon.cpp:121: Using configs in /home/peter/.ola
common/thread/Mutex.cpp:115: Waiting with pthread
common/thread/Thread.cpp:192: Thread pref-saver, policy SCHED_OTH…
-
Log from HiTool and ScreenShot
What wrong ?
```
USB channels were closed successfull…