-
**Hardware:**
SPRacing F3 EVO
**Software:**
Betaflight 3.2.0-RC4, RC3, 3.1.7, 3.0.1 & CleanFlight 2.1.0
Betaflight Configurator 3.2.1 (Chrome Store)
**Set-UP:**
Quadcopter X using DSHOT 600 …
-
I have a spare UART and would like to setup my Unify Pro HV using my FC. SmartAudio is a UART port so it should be possible to use it like the Core OSD would. Would be awesome to use stick commands+au…
-
The new config receiver tab has labels "Stick Min", "Stick Center" & "Stick Max".
This is VERY CONFUSING and many have set these to stick End Point values.
Please correct the labels to what these …
-
I'm not sure #1932 is resolved. I have the same situation and I've redone the connection a couple times. I'm also using SP Racing F3 (non-EVO) with the X4R-SB Rx and using soft serial connection with …
-
Due to my bad English, I made a video without speaking, just showing what happens.
I'll make it well explained here, just look at the video that will see that there is a delay in the servo movement, …
-
Is this possible to add without too much work? Would it be a case of copying it from cleanflight?
-
3 of my Quads drift heavily in Angle/Horizon modes.
All are using Cyclones.
MotoLab Cyclone FC
BLHeli-14.6
Betaflight 2.9
No matter how many times I calibrate the Accelerometer and do an "in flight…
-
I'm using Configurator 3.2.1 and backed up my config because i needed to to a full chip erase.
After the erase, i wanted to restore my configuration - which did pretty much nothing.
I noticed this…
-
Hi,
since the 2.1.0 firmware update my GPS dont work anymore. Im using a Ublox GPS on UART2.
After setting the GPS setting in the PORT menu I activate the GPS feature in the configuration menu. Af…
-
If the SP Racing F3 OSD is upgraded to the latest OSD firmware (v2.0.5 - SPRACINGF3OSD - 09-07-2017 08:47 (stable)) it no longer works with iNav. When you boot up iNav with 1.7.1 - SPRACINGF3EVO on t…