-
I purchased a new ESP32 DOIT DEVKIT. Used the pio run -t upload and pio run -t uploadfs commands to upload the current sketch and preferences. Both were successful. Nothing was connected to the ESP32 …
-
### Preliminary Docs
I confirm that I have read the [CONTRIBUTING](https://github.com/ccrisan/motioneyeos/blob/master/.github/CONTRIBUTING.md) guide before opening this issue.
I confirm that I h…
-
I get "Fixing recursive fault but reboot is needed!" when trying to boot from sdcard using pre-build images. The card was formatted with the specification from readme.
Do you have any idea why?
-
Hi there,
I'm trying to build an esp-matter project using PlatformIO. I used a simple start project with esp-idf as a framework.
Then a file under `src/` called `idf_component.yml` that configu…
-
### The problem
I have configured an I2S media player.
The media player is not discovered by Home Assistant.
I'm assuming the discovery message would be under `homeassistant/media_player`? In t…
-
Hi,
i have some issue with the library. I am using an ESP32-S3 dev kit 1. I have connected three buttons to the ESP and I simply would like to change the station based on the button press.
Once…
-
Hello,
I have had no success compiling the source code. I followed the instruction given in the README file. After configuring using the menuconfig interface, I ran `make flash` after which it will…
-
I'm getting the following on the monitor when running **play_mp3_control** on a ESP32-S3-Korvo-2 v3.1
`I2S: APLL not supported on current chip, use I2S_CLK_D2CLK as default clock source`
## Envi…
-
What are i2s pins and do I need to use 4pin connector to use i2c on this board?
-
Hello,
I have an issue since few month, build of arm64 freeze on ``Preconfiguring packages ...``. I test more than 24h and nothing more.
```
Sending build context to Docker daemon 810.5kB
Ste…