-
The read() function refers to reading the data from the DMX buffer in the chip.
-
I've got a series of RGB and RGBW lights that run off DMX and was thrilled to import them as lights in home assistant, so thank you! I'm running HA on a mac that also runs the QLC program that control…
-
Would anyone be able to add OSC Feedback functionality in order to seamlessly integrate with QLC+, a lighting control software, and other systems which provide the feedback?
-
Would this library be able to listen to the DMX input until there was no data for 1000 ms, then send DMX output once every 1000ms while listening/monitoring the DMX for data inbetween?
-
```
What steps will reproduce the problem?
1. get kinect to work (newest openni, nite and primesense driver)
2. start mappiNect on win7 64 bit but with 32bit drivers
What is the expected output? What…
-
```
What steps will reproduce the problem?
1. get kinect to work (newest openni, nite and primesense driver)
2. start mappiNect on win7 64 bit but with 32bit drivers
What is the expected output? What…
-
The current implementation emulates a network device via USB (CDC NCM) so that the host computer can transfer data via IP packets (web interface, ArtNet, E1.31/sACN). However, attaching a real Etherne…
-
The idle refresh rate of the E1.31 plug in has been observed, via wireshark, as being between a packet every 5-10seconds.
E1.31 6.9.1 states that a period of 2.5seconds or greater, should be treated …
-
Hello
II managed to have OLA working starting with :9090 but not the RDM tester.
Raspberry 5 8gb
It looks that I have an error during installation:
OlaClientWrapperTest.cpp:52:Assertion
Test na…
-
I am using esp8266-07 and after uploading the RX pin project, it is the output pin
I want to make changes so that the TX pin is the DMX output pin
I changed the LED pin according to what I want, but…