-
Hi
I have STM32 set up to communicate with a DS18B20 via OneWire. Communication itself works, i can observe a correct temperature readings from the sensor.
I've attached RPI Zero W flashed with Your…
-
could i get some help implementing this. it would be for the 4k version. ty
https://www.analog.com/media/en/technical-documentation/data-sheets/ds18b20.pdf
-
### Erroneous Behavior
I run a "while/true loop" (every 5 seconds) to read the temperatures from multiple DS18B20 sensors.
When I disconnect the pin of one sensor from the breadboard, in order to em…
-
Hello,
I'm looking for a python library for the ds18b20 temperature sensor that would work with a micro:bit V2.
Do you know if it exists?
Thank you in advance for your help.
G.B.
-
### The problem
When I setup the one_wire component on its own, it finds my DS18B20 sensor and displays the ID, However, when I setup the DS18B20 device as a sensor, with the address specified, I …
-
The original MHI-AC-Ctrl software and PCB have an option to connect a DS18B20 temperature sensor and use that sensor instead of the internal temperature sensor of the HVAC unit.
(upper left corner of…
-
Создаю сценарий: при достижении температуры включать реле но ничего не происходит. Температуру датчик показывает.
И еще одна проблема. Через какое-то время работы значение температуры становиться -1…
-
I've installed the Rikkert-RS package to get temperature of the CPU and additional DS18B20 temperature. Recently I was hoping to add relays to the system by installing RpiGpioSetup.
RpiGpioSetup wor…
-
#### Issue:
Calling `ds18b20` does not work on linux machines. Nothing happens on an `$ ds18b20` or `$ ds18b20 -v` call.
#### Steps to reproduce:
0. Use any debian/ubuntu/raspbian/... machine.
…
-
Working on a firmata implementation that would run on RP2040 wireless for an agriculture sensor project. Wrote a couple of i2c device support using firmata4j and everything works as expected.
Now n…